North America’s top pre and post sales technical support. 4XEM Introduces new indoor Pan Tilt camera IPCAMWPTS. Top Ontario Police Department chooses 4XEM over Bosch. 4XEM launches new web site with enhanced search capabilities.

Enterprise Speed Dome DIP Switch Configuration Guide

Follow the instructions below in order to setup your IP Speed Dome's hardware camera ID, baud rate and protocol.

Speed dome setup	Video platform setup	AP (IP Video Control Center) setup
Camera ID, baud rate and protocol setting in these 3 items should be the same for PTZ control function to work.

Setup Camera ID, Baud Rate and Protocol
Loosen the four screws and de-attach the dome cover from the housing. Follow the tables below to setup each respective parameter. A 10-position DIP SWITCH is furnished on the camera control board. SW1~ SW8 are for ID address setting and SW9/SW10 are for protocol setting. Respective setting is illustrated in the following table:

Address ID								Protocol / Baud Rate
1	2	3	4	5	6	7	8	9	10

Setting of camera ID Address and Communication Protocol

Protocol and baud rate switch

	SW9	SW10
PELCO D-2400	OFF	OFF
PELCO P-4800	ON	OFF
PELCO P-9600 (Recommended)	OFF	ON
EYEVIEW	ON	ON

Camera ID address setting
Please refer to the Appendix. A "Camera hardware ID Setup"

Appendix
Camera Hardware ID Setup
Symbol "o" in the following tables denote setting "ON"